Converting from vBulletin 3.8.11 forum permissions

[PurplePixel]

I managed successfully on setting up the conversion data and start the conversion but I cannot see any of the imported forum in the front-end. I tried to figure it out and discovered that forums do not have permissions set, so that is why.

Is there any way to automate permissions to be set to visible on all imported data? Or at least a fast way to mass-edit the forums? We have a few hundreds...

[Ryan Ashbrook]

Yes, go to your Admin CP > Members > Groups - click the Padlock (titled "Permissions") next to a group, and you can set permissions across the whole suite. Repeat for each group.

[CoffeeCake]

This is intentional behavior. The permissions are not imported.

Our approach was to document and choreograph exact steps that would need to be taken. You can mass assign a permission to all forums or all usergroups (depending on the view you're using), by clicking on the checkbox at the top of the grid (in your screenshot, "See Forum" as an example). We didn't have a quantity of forums where this was an issue, and we were using the conversion to consolidate member groups, so we left this as a manual process to be done while the first few hours of post cleanup were happening and before reopening.

That said, you could automate this and test that as you go through iterations of testing as I previously recommended. Consider looking at using the API to assign group permissions in a process that you execute after the data has been brought over:

https://invisioncommunity.com/developers/rest-api?endpoint=forums/forums/POSTitem

[PurplePixel]

Thanks @Ryan Ashbrook and @Paul E. for advices will check what fits best for us and get back to you if I need more information. 🙂