Make setting as default

[Suyu]

It'd be nice if we could set parameter as default.
Example : In General configuration setting, if you change Board Name, it'll be red and suggest you button REVERT.
Here I suggest the possibility to set a setting as default...

[Antony]

You can set a default by editing the setting configuration, but you'd have to put your board into development mode for that.

Yes, I do agree that there should be a default board name. :)

[Suyu]

It was an example for Default Board name...
(Can I know how put my board in development mode ?)

[Logan]

It was an example for Default Board name...

(Can I know how put my board in development mode ?)

Open init.php

Find:

define ( 'IN_DEV', 0 );

Change to:

define ( 'IN_DEV', 1 );

[Suyu]

Yeah it's a possibility, but i think it is quite fastidious. (hmmm, change it is a little difficult, and without facility)

[Luke]

Just make sure to take your board off development mode when you're done. Certain things are done in development mode both in AdminCP and on the board, and you dont want this to happen on an active board. I would suggest doing this instead if your board is rather busy:

Find

define ( 'IN_DEV', 0 );

Change to:

if( basename( $_SERVER['PHP_SELF'] ) == 'admin.php' ) {
define ( 'IN_DEV', 1 );
}
else
{
define ( 'IN_DEV', 0 );
}

This allows you to put your AdminCP in development mode while leaving your board in non-development mode. Once you are done in AdminCP you can change the "1" to a "0".